De retardatione principii cochleae geminae extruder

Ningbo Fangli Technologia Co., Ltd. est machinamenta mechanica cum 30 annis fere experientiisplastic organo instrumento extrusionem, novum praesidium environmental et novum apparatum materiarum. Cum Fangli instauratio eius innititur postulatis usoris explicata est. Per continuam emendationem, R&D independentem in nucleo technologiae et digestionis & effusio technologiae provectae aliisque mediis, elaboravimusPVC fistula extrusio lineae, PP-R fistula extrusio lineae, PE aquae copia / gas pipe extrusionem lineamquae commendata fuit a Ministerio Constructione Sinensi productis importatis reponere. Titulum "Primo-classis Brand in Zhejiang Provincia" obtinuimus.

In most extruders, the change of screw speed is realized by adjusting the motor speed. The driving motor usually rotates at full speed of about 1750 rpm, which is too fast for an extruder screw. If it rotates at such a fast speed, too much friction heat will be generated, and the uniform and well stirred melt cannot be prepared due to the short residence time of the plastic. The typical reduction ratio should be between 10:1 and 20:1. In the first stage, both gears and pulley blocks can be used, but in the second stage, it is best to use gears and position the screw in the center of the last big gear. For some slow-moving machines (such as twin-screw for UPVC), there may be three deceleration stages, and the maximum speed may be as low as 30 rpm or less (ratio up to 60:1). On the other hand, some very long twin screws for stirring can run at 600 rpm or faster, so a very low deceleration rate and more deep cooling are required.

Si plura indicia requiras, Ningbo Fangli Technologia Co., Ltd. te excipit ut contactum pro singillatim inquisitione recipias, tibi dabimus technicae artis ductu vel apparatu procurationis suggestiones.